Your knowledge database for EMC, Wireless, Product Safety, Sustainability & Global Market Access updates and requirements.
CE – RED Directive – Wideband transmission systems 2400 MHz to 2 483.5 MHz- Starting August 6, 2021, only EN 300 328 Version 2.2.2 will provide a presumption of conformity with the Radio Equipment Directive. Starting August 6, 2021, only EN 300 328 Version 2.2.2 (2019-07) will provide a presumption of conformity with the Radio […]
Read More >>
The Radio Equipment Directive (RED) is a set of standardized rules developed by the European Commission that defines the conditions for putting radio-electric products in the industry. The European Commission issued an Incorporating Action (EU 2020/167) on the harmonized guidelines for communication equipment, which recognized ETSI EN 300 328 as a component of the EU […]
Read More >>The European Commission has published National language requirements for the Radio Equipment Directive (RED; 2014/53/EU) Labeling Manufacturers & Importers shall indicate on the radio equipment their name, registered trade name or registered trademark and the postal address at which they can be contacted or, where the size or nature of radio equipment does not […]
Read More >>European Commission has published National language requirements for the Radio Equipment Directive (RED; 2014/53/EU). Manufacturers & Importers shall ensure that the radio equipment is accompanied by instructions and safety information in a language which consumers can be easily understood and other end‐users, as determined by the Member State concerned. Therefore, Labeling, EU declaration of conformity (DoC), EU‐type […]
Read More >>FAQs – Radio Equipment Directive (RE-D) Q- What is the objective of the RE-D? The Radio Equipment Directive (2014/53/EU) was adopted in 2014 and Member States had to transpose it into their national law before 13 June 2016. It revises the Directive on Radio and Telecommunication Terminal Equipment (1999/5/EC) and sets down requirements on safety, health […]
Read More >>The existing Radio & Telecommunications Terminal Equipment Directive (R&TTED) (1999/5/EC) will be repealed on 13 June 2016 with the Radio Equipment Directive (RED) (2014/53/EU) . Manufacturers who were compliant with the existing legislation (RTTED or LVD/EMCD) will have until 13 June 2017 to comply with the new requirements. What has changed? The RED applies […]
Read More >>
Effective February 06, 2023, FCC new Equipment Authorization Procedures will be required for any TCB submission process. The new Equipment Authorization Procedures required US agent registration with the FCC. The US agent is responsible for representing the equipment manufacturer or importer in all interactions with the FCC regarding […]
Read More >>
Radio – Mandatory TDRA Certification scheme: TDRA certification Process – Type approval Authorities submission – Yes Local representative – Required CBS tests required for Emergency & Telecom products Safety – ECAS Certification scheme: EMSA – ECAS Process – Type approval based on CB or Testing Authorities submission – Yes Local representative – […]
Read More >>
IEC 62368-1 introduction IEC 62368-1 is a safety standard relating to electrical and electronic equipment. in the field of audio, video, information technology and communication. The standard classifies energy sources, establishes protections against them, provides guidelines regarding their application and requirements. This is intended to reduce the likelihood of injury, pain and damage to property […]
Read More >>
The U.S. Federal Communications Commission is seeking public comments and suggestions for improving the performance of radio frequency (RF) receivers. Following to a Notice of Inquiry issued, the Commission believes that its efforts to improve efficiencies in spectrum management need to expand to include all aspects of wireless systems, including both transmitters and receivers. Although current regulations applicable to […]
Read More >>
India’s Department of Telecom (DoT) has cancelled its requirement for mandatory testing and certification of smartphones and certain other consumer electronic products. According to recent reports in the Hindustan Times and other media outlets, the DOT’s action is in connection with its Mandatory Testing and Certification of Telecommunications Equipment (MTCTE) regime, which would require manufacturers […]
Read More >>
CPSO (Consumer Product Safety Office) release new circular (CPSO-310522-05) dated 31, May 2022, updating the changes to the required safety standards for medium risk Controlled Goods, regulated under the Consumer Protection (Safety Requirements) Regulations (CPSR). The new requirements will have the following effective dates: -From 1st June 2024 – for new registrations of Controlled Goods […]
Read More >>
The Australian Communications and Media Authority (ACMA) issued the Radiocommunications (Low Interference Potential Devices) Class License Variation 2022 (No. 1). This document amends the Radiocommunications (Low Interference Potential Devices) Class License 2015 (the LIPD Class License) and is based on the relevant public suggestions but some issues most probably will be reflected in the future […]
Read More >>
Saudi Standards, Metrology and Quality Organization (SASO) notifies about new technical regulation requirements on Restriction of Hazardous Substances in Electrical and Electronic Equipment are coming into force from July 2022. These requirements will be mandatory as below: Small household appliances from July 4, 2022 Large household appliances from October 2, 2022 Information and communication technology […]
Read More >>
